NEC EXPRESS5800/120Lf User Manual page 139

Install the upgrade kit as follows:
1. Observe the safety and ESD precautions listed under General Information
and Static Precautions at the beginning of this chapter.
2. Prepare your system for upgrade. See Preparing Your System for Upgrade
described earlier in this chapter.
3. Remove the left-hand side access panel as described earlier in this chapter.
4. Remove the fan cover as described earlier in this chapter.
5. Release the two disk carrier trays and dummy panel located at the bottom of
the cabinet where the hard disk drive cage is to be installed. They are
released by removing the two screws holding them in place. See Figure
4-51. Save the trays, panel, and screws for future use.
Figure 4-51. Releasing the Disk Carrier Trays and Dummy Panel
6. Slide the new HDD cage into the chassis, approximately half way. This will
allow the interface cable to be connected easily. See Figure 4-52.
Figure 4-52. Installing the HDD Cage
Upgrading Your System 4-53