Daisy Chaining - Bosch VEZ Series Installation And Configuration Manual

6 Connections
5.1.2

Daisy Chaining

In a daisy chain configuration, where multiple domes are connected, the termination switch
must be turned off for all but the last dome. The AutoDome Easy can be daisy chained up to a
maximum of four (4) domes. To daisy chain the unit, do the following:
1.
2.
3.
NOTICE! See Section 6: Address (ID) to set the camera ID before replacing the bubble.
i
4.
5.
6.
7.
8.
9.
10. Connect the shield of the cable to the Head End controller. You do not need to connect
Fig. 5.2 Daisy Chain Configuration
SW601
Terminated
Not Terminated
Table 5.2 Setting the Unit for Termination
December 06, 2006 | F01U074570 | 3.0
Loosen all bubbles in the daisy chain sequence except for the last one. Use the torx
wrench provided to remove the four (4) tamper-resistant screws on each bubble.
Carefully loosen each bubble and allow it to hang from the safety tether.
Locate the SW601 switch and slide to the OFF position except for last dome in the chain.
Locate the cable assembly on the first camera with a two (2) pin black mating connector
on one end and the brown and black flying leads on the other end.
Connect the biphase(+) from the controller to the first camera black lead and secure.
Connect the biphase(-) from the controller to the brown lead on the first camera and
secure.
Connect the biphase(+) from the first camera black lead to the second camera black lead
and secure.
Connect the biphase(-) from the first camera brown lead to the second camera brown
lead and secure.
Repeat steps as required for up to four (4) cameras.
the shield to any AutoDome Easy.
Dome 4
Brown
C(-)
C(+)
SW601
SW601
OFF
ON
Diagram
1
ON
OFF
Installation and Configuration Manual
Dome 2
Dome 3
C(-) C(-)
C(+) C(+)
SW601
SW601
OFF
OFF
SW601
AutoDome Easy
Head End
Dome 1
Biphase
C(-)
C(-)
C(+)
C(+)
SHIELD
Connected
SW601
OFF
Bosch Security Systems, Inc.