Freestanding Optional Equipment - Travis Industries 520-96 Owner's Manual

FREESTANDING OPTIONAL EQUIPMENT

Your Lopi 520-96 appliance comes completely assembled. The options available for the freestanding
method of installation are listed below and require assembly.
1. Pedestal
2. Leg Kit, Steel
3. Leg Kit, Brass
4. Leg Kit, Cast
5. Blower, Rear
6. Outside Air (Available with Pedestal or Outside Air Boot and Legs)
1. Pedestal Assembly:
Open the box marked Pedestal and
remove the pedestal and the two
attachment bolts and washers (3/8"
diameter - 16 x 3/4" hex. head bolts).
Lift the stove onto the pedestal. Line up the threaded bolt holes in the bottom of the stove with the two
holes in the tabs that stick out of the side of the pedestal. Using an open-end or socket wrench, fasten the
pedestal to the stove with the supplied bolts and washers.
2. Steel Leg Kit Assembly:
Open the box marked Steel Leg Kit and remove the four 6 1/2" high black steel legs, complete with
rubber-tipped leveling bolts, the four attachment bolts (3/8" diameter - 16 x 3/4" hex. head bolts) and the
washers.
Raise the stove on some pieces of lumber to a height of about 7".
Line up the hole in the top of the leg with the threaded bolt hole
in each corner of the stove bottom. Using a 9/16" open end or
socket wrench, fasten the leg to the stove with the supplied
attachment bolts and washers, making sure the legs are flush
with the corners of the stove.
To level the stove, first make sure the leveling bolts with the rubber ends (some models come with steel
bolts -- the same directions apply) are screwed into position and backed off just enough to penetrate
below the steel portion of the leg. Unscrew each leveling bolt just enough so each leveling bolt is an
equal distance from the floor. You may wish to use a piece of wood or other spacer to measure this
distance. Next, lower the stove onto the ground and check for a level position. If slight adjustments need
to be made, make sure to first raise the stove before turning the leveling bolts or moving the stove. The
rubber tips of the leveling bolts will tear if they are adjusted or slid while weight is applied to them.
Attach the pedestal
to the stove here
Attach Bolt (with
washer) to Stove
From Below
Page 8
Optional Air Intake Port