Maintenance - JVC VN-H37U Instructions Manual

B
Restart, Initialize (continued)
SD Card
C
Firmware
Update
Version
Program
Number
Format
Perform formatting via the following steps.
1
Go to the Storage page.
2
Check [SD Card Record] for [Storage Mode].
3
Check [Use] for [SD Card].
4
Click the [OK] button.
5
Check [OFF] for [Storage Mode].
6
Click the [OK] button.
7
Go to the Maintenance page.
8
Click the [Format] button.
9
When the status display changes to "Format Complete", the format
operation is complete.
Memo:
● Be sure to format the SD card with the camera before using it. Only an
SD card formatted with this camera can be used.
● It takes about 1 minute to format a 32GB SD card. Do not remove the SD
card during formatting.
● Do not turn off the power during formatting.
● You cannot record to the SD card while formatting is in progress.
● Recording will not automatically begin after formatting has finished. Set
[Storage Mode] via the Storage page (A Page 39) to "SD Card Record",
and configure recording settings.
Displays the update, the version and the program number of the firmware.
Updates the camera firmware and restarts the camera.
Your camera settings are saved. Copy the new firmware file to the PC where
you use the Internet Explorer, and open the file by pressing the [Browse]
button. Press the [Update] button to start firmware updating. Current
services such as JPEG/H.264/MPEG-4 streaming are all stopped. The
firmware updating may take several minutes.
When the firmware is successfully updated, the message is displayed in
Internet Explorer.
Note:
● Do not shut down the system and PC power supplies when the firmware
is being updated and when the camera is restarting immediately after
firmware updating. If the power is shut down, it may cause a malfunction
of camera.
● Before starting firmware updating, terminate any access to the camera (by
the viewer or others), except for the access from the Maintenance Page. If
an access to the camera from anything other than the Maintenance Page
is valid, and if you start to update the firmware, the access from this
Maintenance Page may be disconnected. If it occurs, terminate the
access from anything other than the Maintenance Page. Then, access to
this Maintenance Page again and restart firmware updating.
Displays the version of the firmware.
Displays the program number of the firmware.
67