Chapter 9 Q & A; Installation; Led - Sapido GR-1102 User Manual

Chapter 9
9.1

Installation

1. Q: Where is the XDSL Router installed on the network?
A: In a typical environment, the Router is installed between the XDSL line and the
LAN. Plug the XDSL Router into the XDSL line on the wall and Ethernet port on
the Hub (switch or computer).
2. Q: Why does the throughput seem slow?
A: To achieve maximum throughput, verify that your cable doesn't exceed 100
meter. If you have to do so, we advise you to purchase a bridge to place it in the
middle of the route in order to keep the quality of transmitting signal. Out of this
condition you would better test something else.
Verify network traffic does not exceed 37% of bandwidth.
Check to see that the network does not exceed 10 broadcast messages per
second.
Verify network topology and configuration.
9.2

LED

1. Why doesn't N+ 3.5G Mini Server Router power up?
A: Check if the output voltage is suitable, or check if the power supply is out of
order.
2. The Internet browser still cannot find or connect to N+ 3.5G Mini Server Router
after verifying the IP address and LAN cable, the changes cannot be made, or
password is lost.
A: In case N+ 3.5G Mini Server Router is inaccessible, you can try to restore its
factory default settings. Please press the "Reset" button and keep it pressed for
over 7 seconds and the light of STATUS will vanish. The LEDs will flash again
when reset is successful.
3. Why does N+ 3.5G Mini Server Router shut down unexpectedly?
http://www.sapido.com.tw
Q & A
265 User's Manual V1.0