Servicejournal - Husqvarna Rider ProFlex 18 Operator's Manual

Work done
Pre-delivery service
1. Top up battery with acid and recharge for four hours.
2. Fit steering wheel, seat and any optional equipment.
3. Fit cutting unit.
4. Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit should be
12–15 kg, or set to maximum lift if brush is to be fitted).
Adjust cutting unit so that rear edge is about 2–4 mm higher
than front edge.
Adjust cutting unit height setting so that cutting height limit is 5
mm above the frame of the unit at the lowest cutting height.
5. Check that the oil levels in the engine and transmission are
correct.
6. Check and adjust tyre pressure (60 kPa, 0.6 bar).
7. Connect battery.
8. Fill with fuel and start engine.
9. Check that machine does not move in neutral.
10. Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lift lever safety switch.
Safety switch for the hydrostat pedals.
11. Check engine revs 3,000 75 rpm.
12. Tell customer about:
Need and benefits of following the service schedule.
Need and benefits of having machine serviced every 300
hours.
Servicing and the influence of this journal on the second-hand
value of the machine.
Range of applications for BioClip.
13. Complete proof of sale, etc.
After first 8 hours
1. Change engine oil.
52
– English

SERVICEJOURNAL

Date, mileage, stamp, sign
Pre-delivery service carried out.
No outstanding problems.
Certified: