Internal 3.5" / 2.5" Device Installation - Antec Nineteen Hundred User Manual

2.6 Internal 2.5"/3.5" Device Installation
The NINETEEN HUNDRED has 12 drive bays that are compatible with both 3.5" and 2.5" drives.
To install a 3.5" drive:
1. Remove one of the drive trays by pinching the ends of the tray inward and pulling the drive tray
out.
2. Place your 3.5" drive on the tray so that the holes line up with the silicone grommets.
3. Using the 3.5" drive screws (E in Section 1.3), secure your 3.5" drive to the tray. We recommend
using your hand to find the exact threading of the drive's holes then using a screwdriver to
completely secure your drive. Do not over-tighten the screws as this will minimize the
grommets' ability to reduce vibration.
Use your hand to find the drive's holes.
4. Now that your drive is secure to the tray, pinch
the ends of the tray and insert your drive into
the bay. You will hear your device click into
place.
15
Screw in the holes to secure your drive.
Pinch the ends of the tray and insert your drive until
it clicks.