MK-5005S
Power connection
(A)
Ensure the ON/OFF Switch
is in the OFF position
cutting Setup
NoTES:
1. While the MK-5005S can cut the materials listed earlier in this document, it is
2. Due to the material being cut, the Diamond Blade should not require dressing.
(A)
Set edge of Cutting Guide to
desired cut length on Ruler/Stop
caUTIoN
DO NOT FORCE the blade to cut, it will do the job better and safer at the rate
for which it was designed.
Connect the MK-5005S to
the proper power source
specifically designed to cut concrete masonry. Cutting another material with
the MK-5005S will reduce the life of the Diamond Blade.
If dressing is required, use a soft stone such as sandstone.
Set material against adjustable
Cutting Guide and Ruler/Stop
(B)
(B)
18
oPERaTIoN