Handset At A Glance; Aton Cl300/Cl400 Isdn - Swisscom Aton CL400 User Manual

8.6.06

Handset at a glance

Aton CL300/CL400
Ð
15
10.05.06
INT
14
13
12
11
10
Note:
The handset is not registered to your
ISDN
Aton CL base station; please refer to
page 9.
ISDN
V
INT 1
09:45
SMS
9
Handset at a glance Aton CL300/CL400 ISDN
1 Display in idle status
2 Charge status of the batteries
= e V U
=
flashes: batteries almost flat
e V U
3 Display keys (page 16)
4 Message key
Access to calls and message lists;
Flashes: new message or new call.
5 End call key, On/Off key
End call, cancel function, go back one menu
level (press briefly), back to idle status (press
and hold), activate/deactivate handset
1
(press and hold in idle status)
6 Hash key
2
Confer (Flash) (press and hold),
Toggle between upper/lower case and digits
7 "Swisscom Voice Portal" key
8 Connection socket for headset
9 Microphone
10 Star key
Ringtones on/off (press and hold),
3
Open table of special characters
11 Key 1
Select network mailbox (press and hold)
4
12 Talk key
7
Answer a call, open last number redial list
(press briefly), start dialling (press and hold)
5
13 Handsfree key
Switch between earpiece and handsfree
mode;
Lights up: handsfree activated;
Flashes: incoming call
14 Control key (page 16)
15 Signal strength
Ð i Ñ Ò
|
6
flashes: no reception
8
Note:
The Aton CL300/CL400
shown is just used as an example here. If
you use other handsets, the Aton CL102
or the Aton CL303, the key arrangement
and the menu will be different. For infor-
mation about this, please refer to the user
guide for the handset concerned.
(flat to full)
flashes: batteries charging
(high to low)
ISDN
handset
1