Swisscom Aton CL400 User Manual page 10

First Steps
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
¤
Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage with the notches.
Opening the battery cover
¤
If fitted, remove the belt clip.
¤
Insert your hand into the headset
socket cavity and pull the battery cover
upwards.
Placing the handset in the charging
cradle and registering
¤
Plug the charging cradle mains adapter
into a mains power socket.
¤
Place the handset in the charger with
the display facing forward.
8
Initial charging and discharging of
batteries
If the handset is activated, the flashing
battery icon e in the top right of the dis-
play indicates that the batteries are being
charged.
During handset operation, the battery
icon indicates the charge status of the bat-
teries (page 1). The correct charge level
can only be displayed if the batteries are
first fully charged and discharged.
¤
To do this, leave the handset in the
base station or charging cradle contin-
uously for ten hours. Your handset
activates automatically when you place
it in the base station or charging cradle.
¤
Afterwards, remove the handset from
the charging cradle and do not put it
back again until the battery pack is fully
discharged.
Note:
After the first battery charge and discharge
you may replace your handset in the charging
cradle after every call.
Please note:
u
Always repeat the charging and dis-
charging procedure if you remove the
batteries from the handset and reinsert
them.
u
The batteries may warm up as they are
charging. This is not dangerous.
u
After a while the charge capacity of the
batteries will decrease for technical rea-
sons.
Notes:
– If the handset has switched itself off
because the batteries are flat and is then
placed in the charger, it will switch itself on
automatically.
– Only place the handset in the charging cra-
dle that is intended for it.
For questions and problems see page 51.