Power Module And Alm; Assembly; Pilot Plus Power Module Connector Orientation - Invacare Spectra Blitz Service Instructions Manual

Hide thumbs Also See for Spectra Blitz:

Table of Contents

Invacare

- Dragon Vertic

· Depending on the type of control arm bracket fitted to the wheelchair, remove the screws using

the cross point screwdriver. Remove remote

· Remove the joystick knob (2) by firmly pulling upwards (if required). To access the gaiter.

22.4.2.2 Power Module and ALM

· Gain access to the power module as described in the Battery section of this manual

· Unplug the remaining connectors from the power Module.

· Unplug the ALM module (4) connectors. Use the terminal screwdriver to release the wires

where required.

· Grasp the power module (3) & fixing plate and firmly pull upwards to dislodge the hook and loop

faster strip. Remove this assembly, noting its position.

· Remove the two screws using a screw driver and a 7 mm open ended spanner in one position.

The power module is now free and can be removed from the fixing plate.

· Locate the ALM Fixing plate nuts, and using the 8 mm spanner undo the two nuts and remove

the ALM and plate.

· The ALM is removed from the plate by using a screwdriver and 8 mm open ended spanner

· To re-assemble reverse the above steps, ensuring that all fixing holes are aligned. Take care

not to over tighten the fixing screws.

NOTE:

When fitting the joystick remote screws (2) be sure not to use a torque in excess of 2 Nm.

Position:

A Bus Cable Port

B M1 Motor Cable (RH Motor)

C Battery Cable

D M2 Motor Cable (LH Motor)

E Bus Cable Port.

F Actuator / Lighting Ports

SERVICE MANUAL

Table of Contents