Acs Control System; Inspection; Disassembly; Remote - Invacare Spectra Blitz Service Instructions Manual

Hide thumbs Also See for Spectra Blitz:

Table of Contents

SERVICE MANUAL

22.2

ACS Control System

Description:

1 ACS Remote

3 ACS Power Module

5 Bus Cable

Requirements:

· 7 mm open ended spanner

· 8 mm open ended spanner

· No 2 cross point screwdriver

· Flat blade screwdriver

· Check for any physical damage to the outer case of remote (1).

· Access the power module (3) and actuator module (4) as described in the batteries section of

this user guide and inspect for physical damage.

· Inspect the rubber gaiter around the joystick knob (2) for any cracks, splits or perishing. This

would enable water or moisture to access the unit. This may cause damage to the controller.

· Check the keypad is in good condition with no small tears or cracks.

· Check the bus cable (5) and connectors from the joystick remote (1) are free from damage.

Caution:

· Before any work is carried out on the control system, ensure the power module (3) is

unplugged from the batteries, and the batteries are disconnected.

· Unplug the ACS remote (1) from the power module (3) removing bus cable (5).

· Depending on the type of control arm bracket fitted to the wheelchair, remove the screws using

either the screw driver or 8 mm open ended spanner. Remove remote

2 Joystick Knob

4 Actuator Module

Invacare

- Spectra Blitz

Table of Contents