SERVICE MANUAL
8.2
Disassembly
· Remove screws (1) and remove seat/back board.
8.3
Assembly
· Place seat/back board in correct position and replace screws. Tighten until finger tight.
· Check the position of the seat/back board and then tighten screws securely.
NOTE:
The screws should not be tightened excessively. Excessive tightening could result in damaging
the cross head screw.
9
Installing the Postural Belt
Depending on the type of postural belt, you can install it in two different ways:
· A postural belt with loop endings is installed by putting the loops over the bars of the rear seat
mounting. Refer to How to Install the Postural Belt with Loop Endings on page 14.
· A postural belt with mounting eyelets is installed by screwing it to the bars of the rear seat
mounting. Refer to How to Install the Postural Belt with Mounting Eyelets on page 18.
9.1
How to Install the Postural Belt with Loop Endings
Requirements:
· 17 mm open ended spanner
· 17 mm socket spanner
· Flat bladed screwdriver
14
®
Invacare
- Spectra Blitz