Power Module And Clam; Assembly - Invacare Spectra Blitz Service Instructions Manual

Hide thumbs Also See for Spectra Blitz:

Table of Contents

Invacare

- Dragon Vertic

· Remove the joystick knob (2) by firmly pulling upwards (if required). To access the gaiter.

22.2.2.2 Power Module and Clam

· Gain access to the power module as described in the Battery section of this manual

· Unplug the remaining connectors from the power Module.

· Unplug the actuator module (4) connectors.

· Grasp the power module (3) & fixing plate and firmly pull upwards to dislodge the hook and loop

faster strip. Remove this assembly, noting its position.

· Remove the two screws using a screw driver and a 7 mm open ended spanner in one position.

The power module is now free and can be removed from the fixing plate.

· Locate the actuator module fixing plate nuts, and using the 8 mm spanner undo the two nuts

and remove the actuator module and plate.

· Turn the plate over. The actuator module can be removed from the plate by using a cross point

screwdriver.

· To re-assemble reverse the above steps, ensuring that all fixing holes are aligned. Take care

not to over tighten the fixing screws.

NOTE:

When fitting the joystick remote screws (2) be sure not to use a torque in excess of 2 Nm.

Position:

A M2 Motor Cable (LH Motor)

B Battery Cable

C Bus Cable Port

All connectors are polarized and can only be fitted in one possible position

D Bus Cable Port

E M1 Motor Cable (RH Motor)

F Actuator / Lighting and Bus Cable Port

SERVICE MANUAL

Table of Contents