Figure 31 - Spot Monitor Screen; Figure 32 - Vga Screen - Eneo DLR4-08 Operating Instructions Manual

You can define the screen layout in a variety of formats and set the DVR to sequence through the different screen layouts
(pages) so that all the cameras will be displayed. You can also set up the DVR to display one camera or a group of
cameras all the time while cycling through the remaining cameras in a "cameo" window. This can be done with one
camera displayed full screen while displaying the cameo window as a PIP (picture in picture), or displaying the cameras
in a grid pattern with the bottom right window as the cameo.
NOTE: Sequence cannot be used in the 4x4 display mode of the 16-channel, and 3x3 mode of the 8-channel DVR.
You can adjust the display dwell time by highlighting the box beside Interval and pressing the
select dwell intervals ranging from 1 second to 1 minute.
Highlight Event Monitoring On and press the
it is On, the DVR will display the camera associated with the event when an event occurs.
Highlight the Spot Monitor tab to switch to the Spot Monitor screen.
Figure 31 — Spot Monitor screen.
Highlight the VGA tab to switch to the VGA screen.
Figure 32 — VGA screen.
button. Pressing the button toggles between On and Off. When
You can define which cameras display sequentially on the
Spot Monitor. Highlight the box in the Channels column
and press the button.
Highlight the box beside Resolution and press the
You can select from 800x600, 1024x768 and 1280x1024.
Highlight Full Screen and press the
button toggles between On and Off. When it is On, the
screen on the VGA monitor displays in full screen mode.
Highlighting Preview and pressing the
to preview how the screen will be displayed on the VGA
monitor.
Digital Video Recorder
button. You can
button.
button. Pressing the
button allows you
25