Precautions - Icom IC-M604A Instruction Manual

PRECAUTIONS

RWARNING! NEVER
AC outlet. This may pose a fi re hazard or result in an electric
shock.
RWARNING! NEVER
power source of more than 16 V DC or use reverse polarity.
This will ruin the transceiver.
RWARNING! NEVER
the DC plug at the back of the transceiver and fuse holder. If
an incorrect connection is made after cutting, the transceiver
may be damaged.
CAUTION: NEVER
operation of the vessel may be hindered or where it could
cause bodily injury.
CAUTION:
Changes or modifications to this device, not
expressly approved by Icom Inc., could void your authority to
operate this device under FCC regulations.
KEEP
the transceiver and microphone at least 1 m (3.3 ft)
away from the vessel's magnetic navigation compass.
DO NOT
use or place the transceiver in areas with tem-
peratures below –20°C (–4°F) or above +60°C (+140°F) or,
in areas subject to direct sunlight, such as the dashboard.
v
connect the transceiver to an
connect the transceiver to a
cut the DC power cable between
place the transceiver where normal
DO NOT
use harsh solvents such as benzine or alcohol to
clean the transceiver, as they will damage the transceiver's
surfaces. If the transceiver becomes dusty or dirty, wipe it
clean with a soft, dry cloth.
BE CAREFUL!
The transceiver rear panel will become
hot when operating continuously for long periods of time.
Place the transceiver in a secure place to avoid inadvertent
use by children.
BE CAREFUL!
The transceiver and the optional HM-157
™/HM-162*
COMMANDMICII COMMANDMICIII
proof construction, which corresponds to IPX7. However,
once the transceiver or microphone has been dropped, wa-
terproof protection cannot be guaranteed because of possi-
ble damage to the transceiver's or microphone's case or the
waterproof seal.
* Equivalent to IPX8
™ employ water-