Channel Comments; Aquaquake Water Draining Function - Icom IC-M604A Instruction Manual

■ Channel comments

Each channel can be labeled with a unique alphanumeric ID
of up to 10 characters.
Capital letters, small letters, 0 to 9, some symbols (
and space can be used.
q Select the desired channel.
• Cancel Dualwatch, Tri-watch or Scan fi rst.
w While holding down [H/L], push [16•9] to edit the channel
comment.
• A cursor and the fi rst charac-
ter start alternately blinking.
e Push the appropriate key
several times to select the desired character.
• See the table to the right for selectable characters.
• Rotate [SELECTOR] or push [Y]/[Z] on the microphone to
move the cursor.
• Push [CE] to clear the channel comment.
• Push [CLR] to cancel and exit the screen.
r Push [ENT] to input and set the comment.
• The cursor and the character stop blinking.
t Repeat steps q to r to program other channel com-
ments, if desired.
)
9 9 +06 +06
’0 ’0
’9 ’9
76%  76%   2.'#574'AA 2.'#574'AA
BASIC OPERATION
• Selectable characters
KEY CHARACTERS
 3 < S \ (space)
 # $ % C D E
 & ' ( F G H
 ) * + I J K
 , - . L M N

■ AquaQuake water draining function

The IC-M604A uses a new technology to clear water away from
the speaker grill: AquaQuake. AquaQuake helps clear water
away from the speaker housing (water that might otherwise
muffle the sound coming from the speaker). The IC-M604A
emits a vibrating noise when this function is being used.
➥ While holding down [H/L], turn power ON.
• A low beep tone sounds while [H/L] key is pushed and held to
drain water, regardless of [VOL] control setting.
• All other key operations are disabled while the AquaQuake
function is activated.
To clear water away from the HM-162, hold down [PTT],
and then turn ON the power.
3
KEY CHARACTERS
 / 0 1 O P Q
 2 4 5 R T U
 6 7 8 V W X
 9 : ; Y Z [
   
3
11