Setting Tag Channels; Scan Operation; Starting A Scan - Icom IC-M604A Instruction Manual

■ Setting TAG channels

For more efficient scanning, add the desired channels as
TAG channels, or clear the TAG of unwanted channels.
Channels that are not tagged will be skipped while scanning.
TAG channels can be independently assigned to each chan-
nel group (U.S.A., International and Canada).
q While holding down [H/L], push [CH/WX] several times to
select the desired channel group.
w Select the desired channel to be set as a TAG channel.
e Push [O], then push [5•
TAG
nel as a TAG channel.
• " " appears on the display.
r To cancel the TAG channel setting, repeat step e.
• " " disappears.
Clearing (or setting) all tagged channels
To clear all TAG channels setting in the selected channel
group while holding down [H/L], push [5•
onds (until a long beep changes to 2 short beeps).
• Repeat the above procedure to set all channels in the group as
TAG channels.
[Example]: Starting a normal scan.
9 9
’0 ’0
’9 ’9
76% 76%    
] to set the displayed chan-
] for 3 sec-
TAG
Push
+06 +06
&72 &72
014/#. 014/#. 5%#0
then push
’0 ’0
’9 ’9
+06. +06.

■ Starting a scan

First, set the Priority or Normal scan type, and the scan
resume timer in the Set mode. (p. 47)
q To start a scan, while holding down [H/L], push [CH/WX]
several times to select the channel group, if desired.
w Set TAG channels as described to the left.
e Make sure the squelch is closed to start a scan.
r Push [O], then push [4•
mal scan.
• " " or "
• When a signal is detected, the scan pauses until the signal disap-
pears or resumes after pausing 5 seconds, depending on the Set
mode setting. (Channel 16 is still monitored during a Priority scan.)
• Rotate [SELECTOR] or push [Y]/[Z] on the microphone to
check the scanning TAG channels, to change the scanning di-
rection, or to resume the scan manually.
• A beep tones sounds and "
on Channel 16 during a Priority scan.
t To stop the scan, push [CLR] or repeat step r.
Scan starts.
9 9 +06 +06
&72 &72
6#) 6#)
5%#0
76% 76%    

SCAN OPERATION

] to start a Priority or Nor-
SCN
" appears on the display.
" blinks when a signal is received
When a signal is received
$75; 9 $75; 9 +06 +06
&72 &72
014/#. 014/#. 5%#0 5%#0
’0 ’0
’9 ’9
76%  76%    5#('6; 5#('6;
5
5
15