Uniden DSS7815 Owner's Manual page 12

C. Install the rechargeable battery pack into the handset
The handset is powered by a rechargeable battery pack.
The battery recharges automatically when the handset is placed in
the base unit. To maximize the charge capacity of your battery pack,
Use only the
!
DO NOT plug the telephone cord into the base
Uniden (BT-446)
unit and wall jack until the battery is fully charged.
rechargeable
battery pack
supplied with your 1) Press down on the handset battery case cover (use
cordless
telephone.
Replacement
!
battery packs are
2) Turn the battery pack so that the connector with the
available. See our
website for
information.
www.uniden.com.au
www.uniden.co.nz
3) Make sure you have a good connection by gently pulling
4) Place the battery case cover back on the handset and
the finger indention for a better grip) and slide the
cover downward to remove.
red and black wires is near the jack inside the battery
compartment. Match the connector's wire colors to the
polarity label in the battery compartment (the connector
notches fit into the grooves of the jack only one way).
Push the battery pack connector into the jack until it
clicks into place.
on the battery wires. If the connection is secure, the battery
jack will remain in place.
slide it upwards until it clicks into place.
[11]