Motor Assembly Installation; Blade & Blade Guard Installation; Water Tray Removal & Installation - QEP 60060 Owner's Manual

MOTOR ASSEMBLY INSTALLATION

CAUTION: FOLLOW ALL OF THE
THE SAW TO A POWER SOURCE OR TURNING THE MOTOR ON.
1. Remove motor assembly (5) and saw-frame assembly (6) from the
box. (See Diagram)
2. Motor-support shaft (1) and support-shaft bolt (3) are located inside
the motor assembly.
3. Use the handles to lift motor assembly. Slide motor assembly with the
motor-support shaft into place in the rear support post (4).
4. Once motor assembly is in place, attach the mounting plate
adjustment knob (2) to keep motor assembly stable.
5. From the lifting side, insert motor-support bolt shaft into rear
support post and tighten bolt.
BLADE & BLADE GUARD
1. The blade guard (2) must be installed before the diamond cutting
blade (3) can be attached. (See Diagram)
2. Use the blade guard adjustment knob (1) to fasten the blade guard
firmly against the motor assembly.
3. Carefully raise the cutting head to its highest position and tighten the
adjustment knob on the rear support post so the cutting head is held
firmly in place.
4. Raise the blade guard to the highest level and tighten the blade guard
adjustment knob. Then, remove the blade shaft nut and outer flange.
5. Place the blade onto the shaft, pushing it up against the inner flange.
It is important to be sure the directional arrow is pointing in the
direction of rotation.
6. Replace the outer flange and blade shaft nut. With one hand, hold the
blade and tighten the blade shaft nut with your free hand. Make
certain the nut is firmly tightened with wrench provided.
OVER-TIGHTEN!
7. Release the blade shaft lock after the blade shaft nut is fully tightened.
8. Lower the blade guard into position and tighten the adjustment knob. Then, slightly loosen the rear support
adjustment knob and lower the cutting head so that the blade is
Tighten the adjustment knob firmly to hold the cutting head in place.
WARNING: SETTING THE BLADE TOO LOW MAY CAUSE DAMAGE TO THE CUTTING TABLE. IF THE BLADE IS SET
TOO HIGH, IT MAY CATCH OR GRAB THE MATERIAL BEING CUT, CAUSING DAMAGE AND POSSIBLE INJURY.
WATER TRAY REMOVAL & INSTALLATION
EASY REMOVAL AND INSTALLATION
1. Pull out the drain plug in the bottom of the water tray and drain all
water.
2. Lift up the cutting table with one hand.
3. With the other hand, pull out the water tray from the right-hand side.
4. Lift out the water tray for cleaning. (Hose down and clean as
necessary.)
5. To install, follow steps 2 & 3 in reverse.
6. Next, make sure the drain plug for the water tray is firmly in the drain
hole before filling the tray with water.
7. Lastly, lower the cutting table back to its original flat position.
NOTE: THERE IS NO ADJUSTMENT
WHEN IT IS CORRECTLY INSTALLED.
ASSEMBLY & INSTALLATION INSTRUCTIONS COMPLETELY BEFORE CONNECTING
INSTALLATION
NECESSARY TO THE WATER TRAY
-
DO NOT
1 ⁄ " below the top surface of the cutting table.
4
6 -
MOTOR ASSEMBLY
BLADE INSTALLATION
WATER TRAY REMOVAL
& INSTALLATION
DIAGRAM