Registering Phone; Dhcp; Tftp Or Http & Https - Polycom User Manual

12 Polycom Phones User Guide
4.2.3

Registering Phone

This chapter describes how to register Polycom phone using DHCP, TFTP, HTTP &
HTTPS or DNS SRV.
The following topics are covered:
-

DHCP

- TFTP or HTTP & HTTPS
- DNS SRV
DHCP
4.2.3.1
1. Configure DHCP
Make sure your DHCP router is configured to use option 66 to automatically
instruct phones with the URL for auto provisioning. For more information refer to
your router documentation or contact your network administrator.
2. Phone first boot or user initiated reboot
Auto provisioning process will start during phone first boot or after reboot process
has been initiated by user. DHCP server will instruct the phone where from to
pickup appropriate configuration file. If everything is done as above described, you
should have successfully registered your phone to PBXware. Dial *123 to verify
registration.
TFTP or HTTP & HTTPS
4.2.3.2
1. Network Configuration
If there is no DHCP in your network, you can still auto provision your Polycom phone.
Please refer to your Polycom phone model User Guide for instruction about setting static
IP address. After you configure your Polycom phone to use a static IP address, continue
with the following steps.
Press the Menu button on your phone.
Scroll to Settings and press Select button.
Scroll to Advanced and press Select button.
Enter password and press Enter button. Please note, factory default password
is 456.
Press Select button to enter Admin Settings.
Press Select button to enter Network Configuration.
© 2003 - 2012 Bicom Systems