Menu Operation - Yaesu FT-817nd Operating Manual

M O
ENU
The Menu System allows you to customize a wide variety of transceiver performance as-
pects and operating characteristics. Once you have gone through the various Menu
customization procedures initially, you will find that you will not have to resort to them
frequently during everyday operation.

Menu Operation

1. Press and hold in the
the Menu Item will appear in the display.
2. Rotate the
3. When you have chosen the desired Menu Item
number, rotate the
value or condition for the Menu Item.
4. When you have made your selection, press and
hold in the key for one second to save the
new setting and exit to the normal operation.
In step (3) above, if you press the
of that Menu Item to its factory-default value.
In step (4) above, if you press the
operation without saving the new setting.
Menu Item
01 144 ARS
02 430 ARS
03 9600 MIC
04 AM&FM DL
05 AM MIC
06 AM STEP
07 ANTENNA
08 APO TIME
09 ARTS BEEP
10 BACKLIGHT
11 BATT-CHG
12 BEEP FREQ
13 BEEP VOL
14 CAT RATE
15 COLOR
16 CONTRAST
17 CW DELAY
18 CW ID
58
PERATION
key for one second. The Menu Item number and a brief title for
knob to select the Menu Item you wish to work on.
knob to change the
Function
Activate/deactivate the Automatic Repeater Shift
when operating on the 144 MHz band
Activate/deactivate the Automatic Repeater Shift
when operating on the 430 MHz band
Adjust the audio input level from the TNC
during 9600 bps Packet operation
Enabling/disabling the
on the AM and FM modes
Adjust the microphone gain level for the AM mode
Select the tuning steps
for the knob on the AM mode
Select the antenna connector to be used
on each operating band (HF/50/144/430 MHz)
Select the Auto Power Off time
(time before power goes off)
Select the ARTS beep mode
Select the LCD lamp mode
Select the battery charging time
Select the beep frequency
Select the beep volume
Set the transceiver's circuitry for the CAT baud rate
Select the illumination color for the LCD illumination
Setting of the display contrast level
Set the receiver recovery time
during pseudo-VOX CW semi-break-in operation
Enables/disables the CW identifier
during ARTS operation
key momentarily, it will reset the setting
key momantarily, you will exit to normal
knob
FT-817
Available Values
OFF/ON
OFF/ON
0 ~ 100
ENABLE/DISABLE
0 ~ 100
2.5/5/9/10/
12.5/25kHz
FRONT/REAR
OFF/1h ~ 6h
OFF/RANGE/ALL
OFF/ON/AUTO
1 1
6 /8/10/12 h (hours)
440/880 Hz
0 ~ 100
4800/9600/38400 bps
COLOR1 (Blue)/
COLOR2 (Amber)/
COLOR3 (Violet)
1 ~ 12
10 ~ 500 msec
OFF/ON
Operating Manual
Default
1
1
50
DISABLE
50
1
1
OFF
RANGE
AUTO
1
880 Hz
50
4800 bps
COLOR1
5
250 msec
OFF