Yaesu FT-817nd Operating Manual page 13

FNB-85 N
Charging
Charging of the FNB-85 requires the use of either the supplied battery charger (NC-72B/
C or PA-48C/U), or an external 13.8 Volt (±15%) DC source. If the battery charger is used,
the FT-817 must be turned off during charging; if an external 13.8 Volt DC source is
ND
used (connected via the supplied E-DC-6 cable), then you may operate the FT-817
charging is in progress.
1. Turn the FT-817
connector to the INPUT: 13.8V
2. Plug the battery charger into the nearest AC wall outlet.
3. Press the FT-817
4. Press the key momentarily.
5. Rotate the
on the display.
6. Press the key to select the CHG option (the display will immediately revert to the
regular frequency display).
7. Turn the FT-817
above the main tuning dial is glowing Orange, and the display
will indicate "CHG TIME RMN" and remaining time to indicate
the time remaining before a full charge is achieved on the FNB-
85.
Important Note
Ì The NC-72/PA-48 are not designed to power the transceiver for operation (reception
or transmission).
Ì Please be advised that the NC-72/PA-48 may contribute noise to TV and radio recep-
tion in the immediate vicinity, so we do not recommend its use adjacent to such devices.
For Charging the optional FNB-72 Ni-Cd Battery Pack
If you wish to charge the optional FNB-72 Ni-Cd Battery Pack using the supplied
NC-72B/C or PA-48C/U Battery Charger, you must set the Battery Charging Time
to "6 Hours" (use for NC-72B/C) or "8 Hours" (use for PA-48C/U) via Menu #11,
to prevent over charging the battery. See page 61 for detail.
FT-817 Operating Manual
-MH B
I ATTERY
off (see page 18), then connect the supplied battery charger DC
ND
's switch for one second to turn the transceiver on.
ND
knob so that the function row containing " [ CHG, VLT, DSP ] " appears
off. You will now observe that the LED just
ND
Important Notice
P I
ACK NSTALLATION AND
jack on the rear panel of the FT-817
I
NSTALLATION
.
ND
U
SE
while
ND
11