Setting The Operating Frequency; Stacked Vfo System - Yaesu FT-817nd Operating Manual

S
ETTING THE
1. In the "SSB/CW/DIG" modes, rotate the
knob to set the frequency. Clockwise
rotation of the
erating frequency.
2. In the "AM/FM/PKT" modes, rotate the
knob to set the frequency. Clockwise rotation of the
frequency.
3. You may also use the
DIG" modes. The
frequency when you want to move across the band in a hurry. You can then use the
knob to make fine frequency adjustments.
4. If you press the
change the operating frequency in 1 MHz steps, allowing very quick frequency excur-
sions. This can be particularly helpful on the VHF and UHF bands.
5. In step 2 above, it was mentioned that tuning in the "AM/FM/PKT" modes is accom-
plished using the
you wish to enable the
6. The synthesizer steps for the
Menu #06 for AM, #30 for FM, and #47 for SSB/CW/Digital. See pages 60, 64, and 67
for details.
The main
of the
1. Press the key momentarily, then rotate the
Function Row 1 [ A/B, A=B, SPL ] appears on the display.
2. Now press the
such VFOs provided on each Amateur band, so you may set VFO-A to the CW sub-
band, and VFO-B to the SSB sub-band, if you like. The operating mode will be pre-
served, along with the frequency information, on each VFO.
FT-817 Operating Manual
O
knob increases the op-
knob to adjust the operating frequency in the "SSB/CW/
knob provides faster tuning, ideal for making quick changes in
knob momentarily, then rotate the
knob. By default, the
knob in these modes, use Menu #04; see page 60.
knob may be adjusted independently by mode. Use
knob synthesizer's tuning rate (the number of steps per rotation
knob) can be adjusted using Menu #33. See page 65 for details.
S
TACKED
( A/B ) key to toggle between the "A" and "B" VFOs. There are two
F
PERATING REQUENCY
knob is disabled in these modes; if
VFO S
YSTEM
knob, as needed, until Operating
O
PERATION
knob increases the operating
knob, you can now
21