Tools; System Commands; Remote Log - CTC Union ATU-R140 User Manual

The apply button will temporarily save this connection. To make the change permanent you
need to click on Tools (at the top of the page) and select System Commands. At the system
commands page, click on Save All.
4.7

Tools

The gateway supports a host of tools which will allow you to customize and debug your
gateway.

4.7.1 System Commands

To make the changes permanent you need to click on Tools (at the top of the page) and
select System Commands. The following commands are used to configure the gateway:
a. Save all: Press this button in order to permanently save the current configuration of
the Gateway. If you do re-start the system without saving your configuration, the
Gateway will revert back to the previously saved configuration.
Restart: Use this button to re-start the system. If you have not saved your
b.
configurations, the Gateway will revert back to the previously saved configuration
upon re-starting. NOTE: Connectivity to the unit will be lost. You can reconnect
after the unit reboots.
Restore Defaults: Use this button to restore factory default configuration. NOTE:
c.
Connectivity to the unit will be lost. You can reconnect after the unit reboots.

4.7.2 Remote Log

The remote log feature is used in conjunction with the PC tool (software provided with your
gateway). For PPPoE and PPPoA connections, you can select debug if you want to log the
connection information. This is helpful when trying to debug connection problems.
The remote log feature will forward all logged information to the remote PC. The type of
information forwarded to the remote PC depends upon the Log level. Each log message is
assigned a severity level, which indicates how seriously the triggering event affects Gateway
functions. When you configure logging, you must specify a severity level for each facility;
messages that belong to the facility and are rated at that level or higher are logged to the
destination.
Table 1 defines the different severity levels.
To forward logging information, you need to click on Tools (at the top of the page) and select
Remote Log.
ATU-R140 ADSL Ethernet USB Router User's Guide
Figure 26(Access Control)
Table 1 (Severity Level)
37