Modify An Existing Connection; Modem Setup - CTC Union ATU-R140 User Manual

ATU-R140 ADSL Ethernet USB Router User's Guide
To configure the gateway for a CLIP connection, click on Setup and then click on New
Connection. The default CLIP connection setup is displayed. At the Type field select CLIP
and the CLIP connection setup page is displayed; figure 9 illustrates a typical CLIP
configuration. Give your CLIP connection a unique name; the name must not have spaces
and cannot begin with numbers. In this case the unique name is called CLIP1. Select the VPI
and VCI settings; your DSL service provider or your ISP will supply these; in this case the
DSL service provider is using 0,35. Also select the quality of service (QOS); leave the default
value if you are unsure or the ISP did not provide this information.
Figure 9 (CLIP Connection Setup)
To complete the connection you must now click the apply button. The apply button will
temporarily save this connection. To make the change permanent you need to click on Tools
(at the top of the page) and select System Commands. At the system commands page, click
on Save All.

4.4.2 Modify an Existing Connection

To modify an existing connection, from the Home screen, click setup and then click the
connection you want to modify. The connections are listed as Connection 1 through
Connection 8.
As a note, if you delete the connection, to make the change permanent you need to click on
Tools (at the top of the page) and select System Commands. At the system commands
page, click on Save All.

4.4.3 Modem Setup

To configure the DSL modulation type, go to the Home screen, Click setup. Under WAN
Setup, select Modem Setup. This will bring up the modem setup screen. Leave the default
value if you are unsure or the DSL/ISP did not provide this information. For most all cases,
this screen should not be modified.
The apply button will temporarily save this connection. To make the change permanent you
need to click on Tools (at the top of the page) and select System Commands. At the system
commands page, click on Save All.
20