Static Routing - CTC Union ATU-R140 User Manual

ATU-R140 ADSL Ethernet USB Router User's Guide
To enable Multicasting, from the Home screen, click Advanced and under Advanced, select
Muliticast. Figure 23 illustrates a typical Multicast configuration.
Figure 23 (Multicast)
The apply button will temporarily save this connection. To make the change permanent you
need to click on Tools (at the top of the page) and select System Commands. At the system
commands page, click on Save All.

4.6.11 Static Routing

If the Gateway is connected to more than one network, you may need to set up a static route
between them. A static route is a pre-defined pathway that network information must travel to
reach a specific host or network. You can use static routing to allow different IP domain users
to access the Internet through the Gateway.
The New Destination IP is the address of the remote LAN network or host to which you want
to assign a static route. Enter the IP address of the host for which you wish to create a static
route here. For a standard Class C IP domain, the network address is the first three fields of
the New Destination IP, while the last field should be 0. The Subnet Mask identifies which
portion of an IP address is the network portion, and which portion is the host portion. For a full
Class C Subnet, the Subnet Mask is 255.255.255.0. The Gateway IP address should be the
IP address of the gateway device that allows for contact between the Gateway and the
remote network or host. The Hop Count determines the maximum number of steps between
network nodes that data packets will travel. A node is any device on the network (such as a
router or switch).
To enable Static Routing, from the Home screen, click Advanced and under Advanced, select
Static Routing. Figure 24 illustrates a typical Static Route.
34