Setting Up Your Gateway; Log Into Your Gateway; Home Screen - CTC Union ATU-R140 User Manual

4.

Setting up Your Gateway

This section will guide you through your gateway's configuration. The gateway is shipped with
a standard default bridge configuration; for most users, you may want to change the gateway
from a bridge to a router.
4.1

Log into Your Gateway

To configure your gateway, open your web browser. You may get an error message at this
point; this is normal. Don't panic. Continue following these directions. Type the default IP
address (192.168.1.1) Press the Enter key and the following screen, shown in Figure 1 will
appear. The default user name is Admin (case sensitive) and the password is Admin (case
sensitive).
Note: Before setting up your gateway, make sure you have followed the quick start guide. You
should have your computers configured for DHCP mode and have proxies disabled on your
browser. Also if you access the Gateway, and instead of getting a login screen, the browser
instead displays a login redirection screen, you should check your browser's setting, and
verify that JavaScript support is enabled. Also, if you do not get the screen shown in Figure 1,
you may need to delete your temporary Internet files (basically flush the cached web pages).
4.2

Home Screen

The first screen (Figure 2) that appears (after the log in screen) is the Home screen. From this
screen the user can setup the modem (configure the LAN and WAN connection(s), configure
the advanced configuration options within the modem (security, routing, and filtering), access
ATU-R140 ADSL Ethernet USB Router User's Guide
Figure 1 (Log-in screen)
11