Inserting a scene
You can insert a scene in the middle of a
recorded tape by setting the start and end points.
The previously recorded frames between these
start and end points will be erased. Use the
Remote Commander for this operation.
(1) While your camcorder is in the standby mode,
keep pressing EDITSEARCH, and release the
button at the insert end point [b].
(2) Press ZERO SET MEMORY. The ZERO SET
MEMORY indicator flashes and the counter
resets to zero.
(3) Keep pressing the – 7 side of EDITSEARCH
and release the button at the insert start point
[a].
(4) Press START/STOP to start recording. The
scene is inserted. Recording stops
automatically near the counter zero point.
Your camcorder returns to the standby mode.
ZERO SET
MEMORY
Notes
•The zero set memory function works only for
tapes recorded in the Digital8
•The picture and the sound may be distorted at
the end of the inserted section when it is played
back.
If a tape has a blank portion in the recorded
portions
The zero set memory function may not work
correctly.
[a]
(1)
(2)
(3)
(4)
system.
[b]
[b]
7
[a]
EDITSEARCH
71