Sony Handycam DCR-TRV730E Operating Instructions Manual page 187

Types of trouble and their solutions
In the recording and playback modes
Symptom
The power does not turn on.
The end search function does not
work.
The end search function does not
work correctly.
The battery pack is quickly
discharged.
The battery remaining indicator does
not indicate the correct time or the
power goes off although the battery
remaining indicator indicates that the
battery pack has enough power to
operate.
The cassette cannot be removed from
the holder.
The % and Z indicators flash and no
functions except for cassette ejection
work.
Cause and/or Corrective Actions
• The battery pack is not installed, or is dead or nearly dead.
c Install a charged battery pack. (p. 15, 16)
• The AC power adaptor is not connected to a wall socket.
c Connect the AC power adaptor to a wall socket. (p. 21)
• The tape was ejected after recording.
• You have not recorded on the new cassette yet.
• The tape has a blank portion in the beginning or middle.
• The operating temperature is too low.
• The battery pack is not fully charged.
c Charge the battery pack fully again. (p. 16)
• The battery pack is completely dead, and cannot be
recharged.
c Replace with a new battery pack. (p. 15)
• You have used the battery pack in an extremely hot or
cold environment for a long time.
• The battery pack is completely dead, and cannot be
recharged.
c Replace with a new battery pack. (p. 15)
• The battery is dead.
c Use a fully charged battery pack. (p. 15, 16)
• A deviation has occurred in the remaining battery time.
c Charge the battery fully so that the battery remaining
indicator indicates correct time. (p. 16)
• The power source is disconnected.
c Connect it firmly. (p. 15, 21)
• The battery is dead.
c Use a charged battery pack. (p. 15, 16)
• Moisture condensation has occurred.
c Remove the cassette and leave your camcorder for at
least 1 hour to acclimatize. (p. 209)
(Continued on the following page)
187