User Manual Passive-Infrared Sensor SIP-1212W Important Safety Instructions Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings, Install in accordance with the manufacturer’s instructions.
Page 2
Use only with the cart, stand, tripod, bracket, or table specifi ed by the manufacturer, or sold with the apparatus. When a cart is used. Use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lighting storms or when unused for long periods of time.
EXPLANATION OF GRAPHICAL SYMBOLS The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
Page 4
Please read the following recommend safety precautions carefully. Do not Place this apparatus on an uneven surface. Do not install on a surface where it is exposed to direct sunlight, near heating equipment or heavy cold area. Do not place this apparatus near. Do not attempt to service this apparatus yourself.
IR Sensor at a Glance Terminal Alarm LED Relay PIN BU3 PIN BU1 PIN BU4 Tamper Switch PIN BU2 White Light Filter What’s Included Screw (x2) User Manual/ Bracket 3X10 Flat Head Screw x2 Warranty Card (for fi xing the bracket) Installation To open the cover and to assemble the bracket Turn the screw on the bottom of the sensor...
Page 6
Pull up the lower side of the product in the arrow direction to remove the cover. Use 3mm fl at head screws to fi x the unit to the bracket. Then, make adjustment as necessary. 3X10 Flat Head Screw x2 (for fi...
Page 7
Adjusting the angle in all four directions Adjust the orientation of the sensor in a desired direction, and use the bottom screw to fi x it. Left/Right Up/Down Cable Color & Cover Structure • Black: GND • Red: VCC (12V±15%) ...
Page 8
Specifi cations & Appearance Specifi cations Item Description Input Voltage DC 12V(±15%) Current Consumption Max. 17 mA Sensing Range Max. 12 m Number of Sensing Zones Height 1.8 m ~ 3 m Sensing Speed Min. 0.2 ~ Max. 1.5 m/s Alarm Point of Contact Capacity 100 mA (28V) Tamper Point of Contact Capacity...
Page 9
Correct Disposal of This Product (Waste Electrical & Electronic Equipment) (Applicable in the European Union and other European countries with separate collection systems) This marking on the product, accessories or literature indicates that the product and its electronic accessories (e.g. charger, headset, USB cable) should not be disposed of with other household waste at the end of their working life.