Samsung GP-U999SJVLCAA, 1157809 - Water Leak Sensor Quick Start Manual

Setup

Welcome to your Water Leak Sensor

1. Make sure the Water Leak Sensor is within 15 feet (4.5 meters) of your SmartThings Hub SmartThings Wifi (or compatible device with SmartThings Hub functionality) during setup.
2. Use the SmartThings mobile app to select the "Add device" card and then select the "Water leak sensor" category.
3. Remove the tab on the Water Leak Sensor marked "Remove When Connecting" and follow the on-screen instructions in the SmartThings app to complete setup.

Placement

The Water Leak Sensor detects moisture using two metal leads on the top and two on the bottom of the sensor.

Place the Water Leak Sensor in areas like bathrooms, basements, or cabinets where the top or bottom metal leads can easily detect a pool of water forming.

The Water Leak Sensor can also monitor temperature.

Troubleshooting

Back

Front

1. Hold the "Connect" button for 5 seconds, and release it when the LED starts blinking red.
2. Use the SmartThings mobile app to select "Add device" card and then follow the on-screen instructions to complete setup.

If you're still having trouble connecting the Water Leak Sensor, please visit Support. SmartThings.com for assistance.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Samsung GP-U999SJVLCAA, 1157809 - Water Leak Sensor Quick Start Manual