Table of Contents
Advertisement
LAN Screen
Use the LAN link on the main menu to reach the LAN screen. An example screen is
shown below.
Data - LAN Screen
TCP/IP
IP Address
Subnet Mask
DHCP Server
Buttons
Save
Cancel
Figure 6: LAN Screen
IP address for the Wireless Router, as seen from the local LAN.
Use the default value unless the address is already in use or
your LAN is using a different IP address range. In the latter
case, enter an unused IP Address from within the range used by
your LAN.
The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Network Mask for the
LAN segment to which the Wireless Router is attached. i.e. the
same value as the PCs on that LAN segment.
•
If Enabled, the Wireless Router will allocate IP Addresses to
PCs (DHCP clients) on your LAN when they start up. The
default (and recommended) value is Enabled.
•
If you are already using a DHCP Server, this setting must be
Disabled, and the existing DHCP server must be re-
configured to treat the Wireless Router as the default Gate-
way. See the following section for further details.
•
The Start IP Address and Finish IP Address fields set the
values used by the DHCP server when allocating IP Ad-
dresses to DHCP clients. This range also determines the
number of DHCP clients supported.
See the following section for further details on using DHCP.
Save any changes you have made. Note that if you change the
Wireless Router's IP address, your connection will be lost. You
will have to re-connect using the new IP address.
The "Cancel" button will discard any data you have entered and
reload the file from the Wireless Router.
SIGNAMAX LLC •
www.signamax.eu
17
Advertisement
Table of Contents
