Verifying Printer Setup - Konica Minolta Bizhub 3320 User Manual

3. Open a Web browser, and then type the IP address of your access point in the address bar.
Notes:
- The IP address appears as four sets of numbers separated by periods, such as 123.123.123.123.
- If you are using a proxy server, then temporarily disable it to load the Web page correctly.
4. Access the WPS settings.
5. Enter the eight-digit PIN, and then save the setting.
Connecting the printer to a wireless network using the Embedded Web Server
Before you begin, make sure that:
• Your printer is connected temporarily to an Ethernet network.
• A wireless network adapter is installed in your printer and working properly. For more information, see
the instruction sheet that came with the wireless network adapter.
1. Open a Web browser, and then type the printer IP address in the address field.
Notes:
- View the printer IP address on the printer control panel. The IP address appears as four sets of
numbers separated by periods, such as 123.123.123.123.
- If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2. Click Settings >Network/Ports >Wireless.
3. Modify the settings to match the settings of your access point (wireless router).
Note: Make sure to enter the correct SSID, security method, preshared key or passphrase, network
mode, and channel.
4. Click Submit.
5. Turn off the printer, and then disconnect the Ethernet cable. Then wait for at least five seconds, and
then turn the printer back on.
6. To verify if your printer is connected to the network, print a network setup page. Then in the Network
Card [x] section, see if the status is Connected.

Verifying printer setup

When all hardware and software options are installed and the printer is turned on, verify that the printer is
set up correctly by printing the following:
• Menu settings page—Use this page to verify that all printer options are installed correctly. If an
option you installed is not listed, then it is not installed correctly. Remove the option, and then install it
again.
User's Guide
- 36 -