Table of Contents
Advertisement
3.7 SPECIAL FUNCTION
SHADING DET : Sets the shading calibration that the lens will perform. Only occurs when the entire screen is viewed in white
•
light.(OFF / ON)
SHADING : Select Lens shading compensation. (OFF / ON)
•
DEFECT DET : Compensates for bad pixels that my occur. Occurs when the whole screen is in full black or if there is bad
•
pixelation and it changes the THRS values until the screen is fixed. (OFF / ON)
DEFOG : Carry out defog function: OFF / ON
•
LEVEL : adjust amount of fog on display screen: 0 ~ 10. NOTE: When DEFOG is On, ACE and WDR/BLC function can not
—
turn on.
SYSTEM : Select NTSC or PAL. (NTSC / PAL)
•
HD FORMAT : Select Digital output 1080P or 720P. (1080P / 720P)
•
PG : Select Color pattern generator (OFF / ON)
•
CVBS : Select Composite signal (OFF / ON)
•
COMM : Set up the camera ID, baud rate, protocol
•
ID : Select the camera ID: 1 ~ 255
—
BAUD RATE : Select serial communication speed: 2400 / 4800 / 9600 / 19200 / 38400 / 57600 / 115200 bps
—
PROTOCOL : Select operating protocol: PELCO-D / PELCO-P / UPDATE
—
DEFAULT : All the settings will be restored to the factory default.
•
3.8 DISPLAY
2 Megapixel HDcctv Indoor/Outdoor IR Dome Cameras
SECTION 3: SOFTWARE SETUP
15
Advertisement
Table of Contents
