Table of Contents
Advertisement
SECTION 2: INSTALLATION
After adjusting the tilt, tighten the tilt/lock thumb screw.
4.
Adjust the image with the focus and zoom levers. See the photo "Lens controls" on page 2. After setting the focus and zoom
tighten the focus and zoom set screws until snug.
5.
Configure your camera using the software menus in the OSD. See Software Setup in the following section of this manual.
6.
Place the dome cover over the base and adjust the dome window. Tighten the captive screws that secure the cover to the
base.
7.
Clean the camera dome with an approved glass cleaning solution and a lint free cloth.
Dust can be removed from the unit by wiping it with a soft damp cloth. To remove stains, gently rub the surface with
—
a soft cloth moistened with a mild detergent solution, then rinse and dry it with a soft cloth.
Remove all foreign particles, such as plastic or rubber materials, attached to the camera housing. These may cause
—
damage to the surface over time.
Do not use benzene, thinner or other chemical products on the camera assembly; these may dissolve the paint and
promote damage of the surfaces. Before using any chemical product, read the accompanying instructions carefully.
CAUTION
8
Horizon adjustment
Advertisement
Table of Contents
