Setting The Remote Transmitter And Receiver - Hunter 42798-01 Owner's Manual

3 • Assembling and Hanging the Fan (continued)
3.9
Optional Pipe/Ball Instructions:
Remove the screw and ground wire from the pipe.
4 • Setting the Remote Transmitter and Receiver 4 • Setting the Remote Transmitter and Receiver
IMPORTANT! Before you change the DIP switch settings, make sure the
battery is not connected to the transmitter.
Optional Pipe/Ball Instructions:
Reassemble the ground wire, wedge, pin, ball, and pipe ball screw, in that
order, onto the long pipe/ball assembly. Go back to Step 3.2.
When two or more
fans are located near
each other, you may
want to have the
receiver/transmitter
for each fan set to
a diff erent code, so
that the operation
of one fan does not
affect the operation
of the other fans.
The DIP switches for the receiver (86) are located on the flat surface of
the receiver. The DIP switches for the transmitter (87) are in the battery
compartment.
9 9
42798-01 • 09/16/09 • Hunter Fan Company
3.10
4.1
86
87