Hunter 42798-01 Owner's Manual page 8

3 • Assembling and Hanging the Fan (continued)
3.5
Place the slots over the hooks to hang the fan.
Pipe
3.7
Ball
Optional Pipe/Ball Instructions:
Remove the pipe ball screw from the standard pipe/ball assembly, then
slide the ball off the pipe
Optional Pipe/Ball Instructions:
Your Hunter fan comes with an optional pipe/ball assembly extension
pipe. If you would like to use the enclosed optional 6 inch pipe/ball
assembly, follow Steps 3.6-3.9. Note: The Auto Balance
designed for pipe/ball assemblies that are 6" and shorter. If you use a pipe/
ball assembly longer than 6 inches, do not activate the Auto Balance
system.
Pipe Ball
Screw
Optional Pipe/Ball Instructions:
Remove the pin from the pipe, then slide the wedge off the pipe.
8 8
42798-01 • 09/16/09 • Hunter Fan Company
3.6
Pipe
3.8
Wedge
TM system is
TM
Pin