Da-Lite Tensioned Advantage Electrol Instruction Book page 7

Tensioned Advantage
120V Wiring Diagram with Optional Built-In Video Projector Interface
CAUTION: The projector must be turned off before connecting
the trigger wires to the projector. Failure to do so may damage
the controller.
Use 2-conductor 18–24 gauge wire to extend the low voltage
connection from the projector's 5 or 12-volt screen trigger output
to the length required to reach the VPI. When extending the low
voltage connection from the projector's screen trigger output
polarity does not matter. The red and black wires from the VPI
are interchangeable.
Front of
Wall Switch
5/12 Volt
Screen Trigger
on Projector
Electrol Installation for 120V Screens
® ®
Up Limit
Tactile Button
U P
S T O P
D O W
N U P
S T O
P
Down Limit
D O
W N
Tactile Button
Back of
Wall Switch
RJ-22 Jack
(Connection to
Wall Switch)
VPI Trigger
Module
Black
Red
IMPORTANT NOTE: The wall switch is REQUIRED to make any
limit switch adjustments, EVEN if a third party control system is
used. Therefore, it is advised to wire the switch or provide a
3-conductor connection that is accessible.
3-conductor 20–24 gauge wire can be used in place of the
U P
supplied RJ-14 cable to connect the wall switch. Connect the BUS
S T O
P
terminals on the wall switch to the corresponding BUS terminals
D O
W N
on the splitter board.
Led
RJ-22
Inputs
Bus
RJ-22
Jack
RJ-45 Jack
Power
Wire
White
(Common)
Black
(Hot)
Power Input 120VAC / 60Hz
Up (Dry Contact)
RJ-22
Down (Dry Contact)
Output
Common (Both)
Bus (Bus)
5V (Bus)
RJ-45
Receptacle
Data
Cable
Green (Ground)
(Ground–Must be Connected
to Building Ground)
7