Table of Contents
Advertisement
3 • Assembling and Hanging the Fan
Standard
Mounting
Washer
Step 3-1
Steps 3-2 – 3-4
6
Adapter
Hunter Fan Company
You can assemble your fan for standard or angle mounting as shown
Label
in steps 3-1 – 3-6. For low profile mounting (ceilings less than 8 feet
high), go to steps 3-7 – 3-11 on the next page.
3-1. Remove the label from the standard mounting washer inside the
canopy. Leave the washer in place. (Note: You will not use the
washer included in the parts sack.)
3-2. To assemble fan to hang down from a flat or angled ceiling, place
the canopy with washer, and canopy trim ring around the adapter
so that they rest on the fan assembly.
3-3. Feed the wires from the fan through the downrod.
3-4. Screw the downrod into the fan assembly. Tighten the square
head set screw.
Canopy
Do not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
Downrod
3-5. Raise the fan and place the ball into the hanger bracket.
Canopy
3-6. Align the notch on the ball with the indent in the hanger bracket.
(with Washer)
(Rotate the fan until you hear the notch pop into place.)
Go to 4 • Wiring the Fan.
Canopy
Trim Ring
installation instructions.
Set Screw
Steps 3-5 – 3-6
CAUTION: e downrod has a special coating on the threads.
WARNING: Do not carry or lift fan by canopy.
WARNING: Fan may fall if not assembled as directed in these
Indent
42013-01 • 02/02/05
Advertisement
Table of Contents
