Appendix A - Paradox 1686V User Manual

9.0 Appendix A

Your Spectra keypad can display data one of two ways
when you to program the following parameters :
• User Access Codes (see page 11)
• System's Clock (see pages 7 & 23)
• Auto-Arm Time (see page 21)
Do not read the following if you have not read the
above mentioned sections.
After entering the 3-digit section you wish to program, the
[ ] button will flash. If a value is programmed, the
ENTER
number corresponding to the first digit of the programmed
value will also illuminate. At this point, you can begin
entering the required data. After entering a digit, the
number corresponding to the following programmed digit
will illuminate and so forth. For example, if you wish to
change User Code 004 from 123456 to 454545, after
entering section [004], button [1] will turn ON. Press the
[4] button and button [2] will turn ON, then press the [5]
button and button [3] will turn ON.
After entering the desired 3-digit section and before
entering any data, press the [
Data Display Mode. The [
will flash. Once in the Data Display Mode, pressing the
[ ] button will scroll through the digits of the current
ENTER
section. When viewing the last digit in the section, pressing
the [ ] button will automatically exit the section.
ENTER
OR
] button to access the
ENTER
], [
1
ARM ARM
] and
2
READY
Spectra LED Keypads 35
lights