Front Bracket - Cub Cadet 8454 Service Manual

5.6 FRONT BRACKET

A. TO DISASSEMBLING
1. Remove mounting nut (7), bolt (6) and seal washer
(8).
2. Separate front bracket (2) from front axle support (1).
3. Remove two oil seals (5), DX bush (4) and adjust-
ing plate (3) in front bracket (2).
4. Remove grease nipple (9).
B. TO ASSEMBLE
1. Insert adjusting plate (3) into the inner bore of front
bracket (2).
2. Install DX bushing (4) with a replacing tool
3. Install two oil seals (5) with a replacing tool and
apply grease.
4. Install grease nipple (9), seal washer (8), mount-
ing nut (7) and bolt (6).
5. Install front bracket ass'y (2) on front axle support (1).
6. Apply grease to the inner bore of front bracket (2)
via grease nipple (9).
Tightening Tightening nut
torque (7) of the front
bracket
Tightening bolt
(6) of the front
bracket
• Knock the groove of DX bushing (4)
into the nipple's groove of front bracket
(2) aligned.
CAUTION
• Install the lip area of oil seal (5)
outward.
D569-W02 May-2003
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
98.1 ~ 147.1 N·m
10.0 ~ 15.0 kgf·m
72.3 ~ 108.4 lbf·ft
19.6 ~ 29.4 N·m
2.0 ~ 3.0 kgf·m
14.4 ~ 21.6 lbf·ft
(1) Front Axle Support
(2) Front Bracket
(3) Adjusting Plate
(4) DX Bushing
(5) Oil Seal
FRONT AXLE
569W525A
(6) Bolt
(7) Nut
(8) Seal Washer
(9) Grease Nipple
5-19