Preparation Stage For Disassembling And Assembling - Cub Cadet 8454 Service Manual

3.4 PREPARATION STAGE FOR
DISASSEMBLING AND
ASSEMBLING
DRAINING THE TRANSMISSION FLUID
Draining the Transmission Fluid
1. Place oil pans underneath the transmission case.
2. Remove the drain plugs.
3. Drain the transmission fluid.
4. Reinstall the drain plugs.
(When refilling)
• Fill up from filling port after removing the filling plug
(1) until reaching the gauge (2).
• After running the engine for few minutes, stop it and
check the oil level again, add the fluid to prescribed
level if it is not correct level.
Transmission
Capacity
fluid
IMPORTANT
• Use only SAE 80, 90 gear oil. Use of other oils may
damage the transmission or hydraulic system. Re-
fer to "LUBRICANTS, FUEL AND COOLING WATER"
(Refer to chapter 1)
• Do not mix different brands fluid together.
D569-W02 May-2003
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
34.0
9.0 U.S.gal.
HYDRAULIC SYSTEM
(1) Drain Plugs
(2) Gauge
569W670A
569W671A
6-55