Remote Port Address - Comtech EF Data Radyne RCS20 Installation And Operation Manual

RCS20 M:N Redundancy Switch
User Interfaces
4.3.2.3.2

REMOTE PORT ADDRESS

This subscreen allows the user to modify the RCS20 remote port baud address.
Programming steps:
1. Use the numeric keypad to enter the desired multi-drop address for the RCS20. Valid
addresses are 32 through 255.
2. Press <CLR> or <NEXT> to abort programming (no switch parameters will be changed).
3. Press <ENT> to load the information on the screen into the switch parameter table. Switching
will occur immediately after pressing <ENT>.
Key Label
S1 ---
S2 ---
S3 ---
S4 RETURN
Numeric
---
Keypad
REMOTE PORT ADDRESS :
Function
N/A
N/A
N/A
Press to select the value entered on the keypad and cycle back to the
TERMINAL PORT CONFIGURATION Screen
Use the numeric keypad to enter the desired multi-drop address for the
RCS20. Valid addresses are 32 through 255.
Press <CLR> or <NEXT> to abort programming (no switch parameters
will be changed).
Press <ENT> to load the information on the screen into the switch
parameter table. Switching will occur immediately after pressing <ENT>.
4–39
32
RETURN
Rev. 14
MN-RCS20