Table of Contents
Advertisement
RCS20 M:N Redundancy Switch
Preface
provided on the rear panel of the unit.
•
•
•
Fuses
FOR CONTINUED OPERATOR SAFETY, ALWAYS REPLACE THE FUSES WITH
THE CORRECT TYPE AND RATING.
Typical for either slide-in power module on the rear panel of the RCU (Redundancy
Control Unit):
•
•
Operating Environment
DO NOT OPERATE THE UNIT IN ANY OF THESE EXTREME OPERATING
CONDITIONS:
•
•
•
•
•
•
In Finland: "Laite on liitettävä suojamaadoituskoskettimilla varustettuun
pistorasiaan."
In Norway: "Apparatet må tilkoples jordet stikkontakt."
In Sweden: "Apparaten skall anslutas till jordat uttag."
For AC operation, the RCS20 requires two common 3.15 Amp/250 volts 20mm
x 5mm Slow-blow fuses that are contained within a fuse holder that is press-fit
into the body of the IEC power inlet module.
For DC operation, no fuses are required.
AMBIENT TEMPERATURES LESS THAN 0°C (32°F) OR MORE THAN
50°C (122°F). (MAXIMUM STORAGE TEMPERATURE ALLOWED IS -
20°C (-4°F) TO 70°C (158°F)).
PRECIPITATION, CONDENSATION, OR HUMID ATMOSPHERES OF
MORE THAN 95% RELATIVE HUMIDITY.
UNPRESSURIZED ALTITUDES OF MORE THAN 2000 METRES (6561.7
FEET).
EXCESSIVE DUST.
FLAMMABLE GASES.
CORROSIVE OR EXPLOSIVE ATMOSPHERES.
xiv
Rev. 14
MN-RCS20
Advertisement
Table of Contents
