Table of Contents
Advertisement
™
Digital Energy
Static Transfer Switch
1.1
Save these instructions
This manual contains important instructions that should be followed during erection, installation, use
and maintenance of the Static Transfer Switch. Before attempting to erect, install and use of the
device, carefully read this manual. Keep this manual next to the device for future references
Full understanding of and compliance with the safety instructions and warnings
contained in this manual are
to avoid any dangerous situation during erection, installation, operation and
maintenance work, and to preserve the maximum reliability of the system.
In the event of equipment failures or special problems it is not permitted to take unauthorised remedial
action. In such cases the responsible GE technical service department must be contacted and the
required information obtained.
GE refuses any responsibility in case of non-observance, unauthorized alterations or improper use of
the delivered device.
While every care has been taken to ensure the completeness and accuracy of this manual, GE accepts
no responsibility or liability for any loss or damage resulting from the use of the information contained in
this document
This document shall not be copied nor reproduced without the permission of GE.
Due to technical improvements, some of the information contained in this manual may be changed
without notice
1.2
Safety warnings and symbols
Safety warnings
The text of this manual contains warnings to avoid risk to persons and to avoid damages to the UPS
system and the supplied critical loads. Do not proceed beyond these warnings if you do not fully
understand and/or are not able to meet the mentioned conditions.
The non-observance of the warnings reminding hazardous situations could result in human injury and
equipment damage. Please pay attention to the meaning of the following warnings and symbols.
WARNING !
Refers to procedures or operations which, when not correctly performed,
could cause personal injury or serious damage to the system
NOTE
Warns the user about important operations or procedures described in this
manual
Safety Symbols
CAUTION
The product may be in danger: when procedures or operations are not
correctly performed, damage to the product may be the result.
DANGER OF PARTS ELECTRICALLY LIVE
Related to all situations with potentially hazardous voltage
OPM_STS_400_25A_100_1GB_V011
1 - Important Safety Instructions
THE ONLY CONDITION
3
GE DE STS: installation and operating manual 1.1 (GB)
g
Advertisement
Table of Contents
