Fault Finding - Triton Tyne Installation And Operating Instructions Manual

The following can be carried out by a competent person
Problem/Symptom Cause
 Water too hot.
. Temperature control
incorrectly commissioned.
. not enough cold water
flowing through shower.
.3 Increase in the ambient
cold water temperature.
.4 Cold water supply
blocked.
. High volume of cold
water drawn off elsewhere.
 Water too cold.
. Temperature control
incorrectly commissioned.
. not enough hot water
flowing through shower.
.3 Decrease in the
ambient cold water
temperature.
.4 Insufficient hot water
supplies from the heating
system.
. Hot water supply
blocked or restricted.
. Flow regulator not
fitted.
3 High water
3. Flow regulators not
flow and/or poor
fitted.
performance on a
mains fed system.
4 Water does not
4. Water supplies cut off.
flow or shower
pattern collapses
4. Shower unit blocked.
when another
4.3 blockage in pipework.
outlet is turned on.
Bath shower mixer

FaUlT FInDInG

Action/Cure
.. Refer to commissioning section.
.. Turn temperature control anti-clockwise.
.3. Turn temperature control anti-clockwise.
.4. Turn off shower and consult a competent
plumber or contact Triton Customer Service.
.. Reduce the simultaneous demand from
the supply.
.. Refer to commissioning section.
.. Turn the temperature control clockwise.
.3. Turn the temperature control clockwise.
.4. Make sure heating appliance is set to
maximum or has sufficient stored hot water.
.4. Make sure heating appliance is igniting by
trying a hot water tap elsewhere.
.. Turn off shower and consult a competent
plumber or contact Triton Customer Service.
.. Fit a flow regulator in the mixer
showerhead outlet; see 'instantaneous gas water
heaters'.
3.. Fit a flow regulator in the mixer
showerhead outlet.
4.. Check water elsewhere in house and if
necessary contact local water company.
4.. Inspect the inlet filters. Clean if necessary.
4.3. Turn off the shower and consult a suitably
competent plumber.
3