Final Assembly - Meiko K-44E Owner's Installation, Operation And Maintenance Manual

Load end of
machine (viewed
from rear)

3.17 Final Assembly

1. Check and tighten all electrical terminal
screws.
2. Replace all panels onto the warewasher.
3. Check that all tools, hardware, metal shav-
ings or filings, etc. are removed from in-
side the machine.
4. Check that the wash arm manifolds, scrap
screens, curtains, and all other removable
components are correctly installed in the
machine.
5. Check that the front access door(s) are
closed.
6. Switch the circuit breaker/fused discon-
nect to the ON position.
7. Switch the POWER ON/OFF switch to the
ON position. Allow the machine to fill.
8. Load several empty racks into the
machine, checking that the racks move
smoothly without binding and that the
wash and rinse arms (and prewash arms,
if so equipped) activate when a rack
reaches the zone.
9. Prime the detergent and rinse aid pumps
according to the manufacturer 's
instructions. The chemical installer should
check for correct chemical concentration
at this time.
10.Adjust the baffles inside the vent cowl
Figure 3-13: Drain connection
If it is necessary to re-
route the drain line:
If possible, the
machine drain
can be positioned
directly above 4"
or larger floor
drain.
3" NPT adapter
(supplied)- connect
to 3" NPT line
(supplied by others)
Machine
drain
Rubber
boot
(supplied)
Clamp
(supplied)
Direct connection
to 3" OD drain line
(supplied by others)
collars (if so equipped). Refer to Figure
3-3 (on Page 6). The baffles should be
opened just enough to prevent steam from
exiting the ends of the machine with the
curtains in place.
After positioning the baffles, tighten the
hex bolt on the front of the cowlings to
hold them in place.
11. Allow the racks to exit the machine. Switch
the POWER ON/OFF switch to the OFF
position. Switch the circuit breaker/fused
disconnect to the OFF position.
12. Pull the external drain handle(s) to empty
the machine.
13. Remove the scrap screens, clean them if
they are soiled, and allow them to air dry.
14. Remove the wash, rinse (and prewash if
so equipped) arm manifolds, clean them
if necessary, and allow them to air dry.
15. Access the two water inlets (see Figure
3-4). Check the dirt traps and clean them
if necessary.
16. Replace all components into the dish-
washer. The machine is now ready for
regular operation.
IMPORTANT
The appliance's warranty is not valid until a
Meiko Authorized Service Agent performs a
Performance and Installation Inspection.
S 3 - I
ECTION NSTALLATION
Page 13