Table of Contents
Advertisement
BIOS Setup Utility
Onboard Serial Ports (Continued)
Onboard Serial
Ports
UR2 Duplex
Mode
Use IR Pins
3-5.6 Onboard Parallel Ports
Onboard Parallel
Ports
Onboard Parallel
Port
Parallel Port Mode
If [Parallel Port Mode] is set to [EPP] mode
EPP Mode Select
If [Parallel Port Mode] is set to [ECP] mode
ECP Mode use
DMA
Setting
Half
Duplex
IR-Rx2Tx2
RxD2,TxD2
Setting
Disabled
378/IRQ7
3BC/IRQ7
278/IRQ5
SPP
EPP
ECP
ECP+EPP
EPP 1.9
EPP 1.7
3
1
Description
Choose [Half] or [Duplex] to
set UR2 in half duplex mode
or full duplex mode
respectively. Refer to your IR
device specifications to select
the suitable mode.
Depending on the capabilities
of the receiving device, set
this item to full or half
duplex. (Full duplex allows
sending and receiving
simultaneously, halt duplex
only allows sending and
receiving to occur separately).
Description
Choose the printer I/O
address.
The mode depends on your
external device that
connects to this port.
Select EPP port type 1.9
Select EPP port type 1.7
Choose DMA3
Choose DMA1
70
SY-6ICA
Note
Default
Default
Note
Default
Default
Default
Default
Advertisement
Table of Contents
