Advantage Engineering Maximum Instruction Manual page 30

MK Series Portable Chiller : Air-Cooled : HE INSTRUMENT
2.
a. The available parameters are listed here and are
explained in detail in the following paragraphs:
NORMAL DISPLAY MODE
SP - setpoint temperature
tON - tonnage display in CAPACITY window
PCt - percent display in CAPACITY window
HI - high temperature deviation limit
Lo - low temperature deviation limit
LoF - low flow limit
Pro - protocol selection
Adr - protocol address selection
rAt - protocol baud rate selection
Unt - temperature/flow unit selection
EXTENDED DISPLAY MODE:
AFL - alternate flow sensor selection
int - internal small flow sensor selected
ALT - large flow sensor selected
ton - chillers size in tons
CAP - capacity display selection
Prb - from process probe calibration
LPt - low pressure time delay
TEMP: illuminates when the following parameters are
selected:
SP - setpoint temperature
tON - tonnage display in CAPACITY window
PCt - percent display in CAPACITY window
HI - high temperature deviation limit
Lo - low temperature deviation limit
a. 'SP': indicates the setpoint temperature can be
adjusted. Adjust the setpoint temperature by:
1. Use the SELECT key to index to the 'SP'
display in the TEMPERATURE DISPLAY
window (the TEMP light is illuminated).
The setpoint temperature value is displayed
in the SETUP DISPLAY window. Use the UP
arrow or DOWN arrow keys to select the
setpoint temperature value.
2. When the instrument is in the default state
(TO process temperature display), the
operator may adjust the setpoint
temperature with the UP arrow or DOWN
arrow keys without first using the select
key. However, if the instrument is in any
ADVANTAGE ENGINEERING, INC.
525 East Stop 18 Road Greenwood, Indiana 46142
317-887-0729
Service Department Fax: 317-885-8683
Email: service@AdvantageEngineering.com
Fax: 317-881-1277
Page: 30